No products
The premium Fenix TK25 IR tactical flashlight offers up to 1000 ANSI lumens of white light plus two 850nm wavelength infrared LEDs and a maximum output of up to 3000mW. With an aerospace-grade hardened aluminum body, the flashlight is damn durable, waterproof and dustproof to IP68 standard. Five light modes ensure that you can always choose the right intensity for the situation.
By buying this product you can collect up to 28 points.
View loyalty points rules.
: FENIX
FE18650LI35
The top-of-the-line Fenix 18650 3500 mAh rechargeable batteries (ARB-L18-3500) with electronic protection are based on the top NCR18650GA cells from Panasonic / Sanyo with improved LiNiCoO2 technology, which brings higher safety and longer life. Li-ion rechargeable batteries are characterized by a very high capacity, do not suffer from the memory effect...
: FENIX
FERCR123ALIIONUP
: FENIX
FENIAER03V20
Tactical cable switch AER-03 V2.0 is designed only for Fenix TK16 (does not fit Fenix TK16 V2.0), Fenix TK20R, Fenix TK25 IR, Fenix TK25 R&B, TK25 Red, TK25 UV, Fenix TK26R and Fenix TK32.
The powerful Fenix TK25 IR tactical flashlight offers a peak light output of up to 1000 ANSI lumens of white light plus two infrared LEDs with a wavelength of 850nm and a maximum output of 3000mW. This wavelength is compatible with most night vision systems. The very rugged and waterproof design and the double layer body construction predestines this tactical flashlight for harsh outdoor conditions, for professionals, armed forces and hunting. The Fenix TK25 IR flashlight uses a dual tactical switch that allows for faster and more reliable control in crisis situations. For example, it can be easily switched directly into strobe mode. The flashlight is powered by a digitally controlled constant current to guarantee a constant light output even when the battery voltage is reduced (when the batteries are slowly discharging).
The Fenix TK25 IR has a total of five white light modes with up to 110 hours of light and two infrared light modes. Also included is a swivel case that is designed for easy and quick detachment of the flashlight.
Switching between white and infrared light modes is very easy, just rotate the flashlight head 90°. However, due to the magnetic sensors in the head of the flashlight, it cannot be used with a magnetic gun mount, which interferes with its proper function.
All flashlight parameters (luminous flux, battery life, waterproofness, range and shock resistance) are measured in accordance with ANSI/NEMA FL 1-2009.
To turn on, press the larger button located on the end of the flashlight, press the button for immediate activation. Press the adjacent toggle button to switch between power modes at any time during operation. To switch to flash mode with the flashlight on, hold the toggle button for approximately 1 second. To turn the flashlight directly into strobe mode, press and hold the toggle button. Switch between white and infrared modes by turning the flashlight head 90°.
Removing the clip - unscrew the tactical ring and pull the clip off the flashlight body, screw the tactical ring back on.
Use only high quality 3V CR123A batteries and 18650 li-ion batteries to avoid damage to the flashlight, for example due to battery leakage.
Insert the batteries with the positive pole towards the head of the flashlight.
If the protective rubber rings appear damaged after prolonged use, replace them. The rings should also be lubricated to prevent erosion of the rubber. By following these rules, the flashlight will be properly protected against water.
If the flashlight flickers, does not switch to higher power modes, or does not light up, it may be due to one of the following reasons:
The batteries are almost dead - replace them.
The contacts inside the flashlight are dirty - clean them with a cotton swab dipped in alcohol.
The head, body or back of the flashlight is loose - tighten them.
Warranty five years.
Color | Black |