SorboPad L96 (20mm cylinder) - 70D - 3,5mm (0.1")

You won't silence your airsoft gun with a suppressor because the loudest sound of manual and AEG weapons comes from inside the gun, the impact of the piston head on the cylinder (plus the sound of gears and the motor in the case of AEGs).
A suppressor with damping foam on an unsilenced weapon is more of a decorative accessory, like a small bandage on a massive wound.
It is necessary to quiet your weapon primarily from the inside by dampening these impacts, and one of the significant aids is Sorbopad.
Sorbopad is a impact surface for the piston in AEGs and manual rifles. It is installed on the cylinder head and dampens piston impacts, thus reducing the shot noise and protecting internal parts from the force of impacts.
It is made of Sorbothane material, which is a special material for absorbing shocks and vibrations, patented and manufactured in the USA.

Its use brings a couple of significant advantages:

• Extends the lifespan of internal parts and for AEG weapons, even ZnAl gearboxes.
• Provides an effective means of suppressing the shot sound of your rifle.
• Helps improve the angle of engagement of gears on the piston teeth (AOE) in AEG weapons.

SorboPad from Epes can be purchased in the following variants (drive type, hardness, and length):

1. According to the type of weapon drive:

a) Manual rifles

• L96/M24 with a 20mm cylinder
  Well MB01, MB08
  Classic Army M24 SW
  SSG24, SSG96
  Snow Wolf M24
  
  
• VSR with a 22mm cylinder (and similar)
  TM VSR10
  CM.700, CM.700A, CM.701, CM.702, CM.708
  Well MB02, MB03
  JG BAR10
  Classic Army M24 LTR
  SSG10

b) AEG weapons

• Size between rings 20 x 6 mm, ideal in combination with EPeS Cylinder Head without impact rubber

2. According to the hardness of Sorbopad:

• 40 D - for springs up to SP110 (for machine guns SP100, for DMR SP120, and for manual rifles SP120-130)
• 50 D - for springs up to SP120 (for machine guns SP110, for DMR SP130, and for manual rifles SP130-140)
• 60 D - for springs up to SP130 (for machine guns SP120, for DMR SP140, and for manual rifles SP140-150)
• 70 D - for springs up to SP140 (for machine guns SP130, for DMR SP150, and for manual rifles SP150-160)

For stronger springs, it is advisable to use a classic rubber stopper on the cylinder head.

3. According to length (suitable for setting AOE in AEG weapons):

• 3.5mm
• 4.2mm
• 5.8mm
• 7.4mm
• Set of all 4 lengths from 1 Duro hardness (if you're not sure which length you'll need exactly)